The Airborne Charging Handle (ACH) was developed at the request of an elite organization famous for its expertise in aerial insertion. The organization requested a lower profile lever design to reduce the chances of snagging. The ACH’s lower profile design is especially ideal for rifles where the primary sighting system is a red dot or similar low profile optic system. The ambidextrous ACH is 3D machined from a solid block of aircraft grade 7075-T6 aluminum. Shortened levers are dual contoured with gently concaved radius cuts in the vertical and horizontal planes. The handling surfaces of the levers are checkered for confident operation while wearing gloves. A taller fence at the rear of the ACH aids in redirecting gas blow back when shooting with short barreled and suppressed weapon systems. The ACH and its components are Type 3 Hard coat anodized and are available in Black and DDC (Desert Dirt Color).
Disclaimer: Our e-commerce site uses stock images for item photography. In most cases, these are completely accurate however there are some cases where the image may not wholly reflect the item being purchased. It is your responsibility to verify the UPC of the item you are purchasing from us with the manufacturer to confirm you are placing an order for the correct item.
